HomePage Forums Troubleshooting CPR Call Blocker CPR Call Blocker screen shows ERROR

Topic Resolution: Not a Question

This topic contains 0 replies, has 1 voice, and was last updated by  cprsupport 2 years, 1 month ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #612

    If CPR Call Blocker screen is showing ‘ERROR’ – the most common cause for this is when there has been an interruption to the signal or power on the CPR Call Blocker such as with a line power surge

    To resolve this, please disconnect the CPR Call Blocker by removing the cable out of the LINE jack on the CPR Call Blocker for 3-5 mins

    After 3-5 mins, when you reconnect the CPR Call Blocker the ERROR message should have gone and your blocked numbers will still be in place and the CPR Call Blocker should work as normal

    If disconnecting the Call Blocker for 5 minutes does not resolve the issue, please try disconnecting for 1 hour 5 minutes and this should fully clear the issue

    If you need any further assistance, please contact us

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.